3Com 5500G-EI - Qos-Profile; Qos-Profile User-Based

308 CHAPTER 8: USING QOS/ACL COMMANDS
qos-profile Syntax
qos-profile profile-name
undo qos-profile profile-name
View
System View
Parameter
profile-name : QoS profile name, a string of one to 32 characters, starting with
letters [a-z, A-Z] and excluding all, interface, and user which are reserved as
keywords.
Description
Use the qos-profile command to create a QoS profile and enter the
corresponding view. For an existing profile, you can directly enter the
corresponding view.
Use the undo qos-profile command to delete a QoS profile.
You cannot delete the specific QoS profile which has been applied to the port.
Example
To create QoS profile student, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500] qos-profile student
[SW5500-qos-profilestudent]
qos-profile user-based Syntax
qos-profile user-based
undo qos-profile user-based
View
Ethernet Port View
Parameter
None
Description
Use the qos-profile user-based command to configure application mode on
the port of the QoS profile.
Use the undo qos-profile user-based command to restore the default
(port-based) application mode.
By default, port-based application mode is selected on the port.