QoS Configuration Commands List 293
Inbound:
Matches: Acl 2000 rule 1 running
Mirrored to: monitor interface
display qos-interface
traffic-limit
Syntax
display qos-interface {
interface-name | interface-type
interface-num | unit-id
} traffic-limit
View
All views
Parameter
interface-name | interface-type interface-num
:: Specifices an Interface of
the Switch, for more information, refer to the
port command in this manual.
unit-id
: Unit ID of the Switch.
Description
Use the display qos-interface traffic-limit command to view the traffic
limit settings. If you set the port parameters, the configuration information about
the specified port will be displayed. The information displayed includes the ACL of
the traffic to be limited, the limited average rate and the settings of some related
policing action.
Related commands: traffic-limit.
Example
Display the traffic limit settings.
<SW5500> display qos-interface gigabitethernet1/0/1 traffic-limit
GigabitEthernet1/0/1: traffic-limit
Inbound:
Matches: Acl 2000 rule running
Target rate: 128 Kbps
display
qos-interface
traffic-priority
Syntax
display qos-interface {
interface-name | interface-type
interface-num | unit-id
} traffic-priority
View
All views
Parameter
interface-name | interface-type interface-num
:: Specifies an interface of
the Switch, for a detailed description, refer to the
port command in this manual.
unit-id
: Unit ID of the Switch.
Description
Use the display qos-interface traffic-priority command to view the
traffic priority settings.
To Next Page
Loading...
