PoE Configuration Commands 95
Description
Use the display poe powersupply command to view the parameters of the
power sourcing equipment (PSE).
Example
Display the PSE parameters.
[SW5500]display poe powersupply
PSE ID :1
PSE Legacy Detection :disable
PSE Total Power Consumption :12000 mW
PSE Available Power :268000 mW
PSE Peak Value :12000 mW
PSE Average Value :12000 mW
PSE Software Version :290
PSE Hardware Version :000
PSE CPLD Version :021
PSE Power-Management mode :auto
poe enable Syntax
poe enable
undo poe enable
View
Ethernet Port View
Parameter
None
Description
Use the poe enable command to enable the PoE feature on a port.
Use the undo poe enable command to disable the PoE feature on a port.
By default, the PoE feature on each port is enabled.
Example
Enable the PoE feature on the current port.
[SW5500-GigabitEthernet1/0/3]poe enable
Port power supply is enabled
# Disable the PoE feature on the current port.
[SW5500-GigabitEthernet1/0/3]undo poe enable
Port power supply is disabled
poe legacy enable Syntax
poe legacy enable
undo poe legacy enable
To Next Page
Loading...
