84 CHAPTER 3: USING VLAN COMMANDS
By default, when all Ethernet ports are in DOWN status in VLAN interface, the
VLAN interface is in DOWN status and is disabled. When there is one or more
Ethernet ports in VLAN interface are in UP status, the VLAN interface is UP.
This command can be used to start the interface after the related parameters and
protocols of VLAN interface are set. Or when the VLAN interface fails, the
interface can be shut down first and then restarted, in this way, the interface may
be restored to normal status. Shutting down or starting VLAN interface will not
take any effect on any Ethernet port of this VLAN.
Example
Restart interface after shutting down the interface.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface2
[SW5500-Vlan-interface2]shutdown
[SW5500-Vlan-interface2]undo shutdown
vlan Syntax
vlan
vlan_id
undo vlan
vlan_id
{ [to
vlan_id
] | all }
View
System View
Parameter
vlan_id:
Enter the ID of the VLAN you want to configure, in the range 1 to
4094.
all: Delete all VLANs.
Description
Use the vlan command to enter the VLAN view, and use the related configuration
commands. Use the
undo vlan command to exit from the specified VLAN. VLAN 1
is default VLAN and cannot be deleted.
Related commands: display vlan.
Example
To enter VLAN 1 view, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]vlan 1
To Next Page
Loading...
