PIM Configuration Commands 279
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500]pim
[SW5500-pim]source-policy 1
[SW5500-pim]quit
[SW5500]acl number 1
[SW5500-acl-basic-1]rule permit source 10.10.1.2 0
[SW5500-acl-basic-1]rule deny source 10.10.1.1 0
static-rp Syntax
static-rp
rp-address
[
acl-number
]
undo static-rp
View
PIM View
Parameter
rp-address:
Static RP address, a legal unicast IP address.
acl-number:
Basic ACL, used to control the range of the multicast group served
by the static RP, which ranges from 2000 to 2999. If an ACL is not specified at
configuration, static RP will serve all multicast groups; if an ACL is specified, static
RP will only serve the multicast group passing the ACL.
Description
Use the static-rp command to configure static RP.
Use the undo static-rp command to remove the configuration.
The Static RP functions as the backup for a dynamic RP so as to improve the
network robustness. If the RP is elected by the BSR mechanism, static RP will not
work.
All routers in the PIM domain should be configured with this command and be
specified with the same RP address.
The new configuration overwrites the old one if you run the command for a
second time.
Related command: display pim rp-info
Example
Configure 10.110.0.6 as a static RP.
<SW5500> system-view
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500]pim
[SW5500-pim]static-rp 10.110.0.6
To Next Page
Loading...
