314 CHAPTER 8: USING QOS/ACL COMMANDS
v2c: V2c security mode.
v3: V3 security mode.
groupname
: Group name, ranging from 1 to 32 bytes.
authentication: If this parameter is added to configuration command, the
system will authenticate but not encrypt SNMP data packets.
privacy: Authenticates and encrypts the packets.
read-view: Sets read-only view.
read-view
: Read-only view name, ranging from 1 to 32 bytes.
write-view: Sets read-write view.
write-view
: Read-write view name, ranging from 1 to 32 bytes.
notify-view: Sets notify view.
notify-view:
Notify view name, ranging from 1 to 32 bytes.
acl
acl-number
: the number identifier of basic number-based ACLs, ranging
from 2000 to 2999
Description
Using the snmp-agent group command, you can configure a new SNMP group
and reference the ACL to perform ACL control to the network management users
by
acl
acl-number
. Using the undo snmp-agent group command, you can
remove a specified SNMP group.
Example
Creates a new SNMP group: MyCompany, and reference the ACL 2001 to perform
ACL control to the network management users (basic ACL 2001 has already been
defined).
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]snmp-agent group v1 MyCompany acl 2001
snmp-agent usm-user Syntax
snmp-agent usm-user { v1 | v2c } u
ser-name group-name
[ acl
acl-number
]
undo snmp-agent usm-user { v1 | v2c }
user-name group-name
snmp-agent usm-user v3
user-name group-name
[ authentication-mode {
md5 | sha }
auth-password
] [ acl
acl-number
]
undo snmp-agent usm-user v3 u
ser-name group-name
{ local | engineid
engineid-string
}
View
System View
To Next Page
Loading...
