3Com 5500G-EI - Display Ntp-Service Trace

NTP Configuration Commands 503
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 0.00 ms
reference time: 00:00:00.000 UTC Jan 1 1900(00000000.00000000)
The following table describes the outputs:
display ntp-service trace Syntax
display ntp-service trace
Views
All views
Parameter
None.
Description
Use the display ntp-service trace command to display the brief information
about every NTP server on the way from the local equipment to the reference
clock source.
This command will be ineffective when the switches form an XRN network.
Example
<SW5500>display ntp-service trace
The information displays in the following format:
Table 68 NTP service status information
Output Meaning
clock status:unsynchronized Local clock status: do not synchronize to any remote NTP
server.
clock stratum: 16 Indicates the NTP stratum of local clock
reference clock ID Indicates the address of a remote server of the reference
ID, in the case that the local system has been
synchronized by a remote NTP server or the ID of some
clock source.
nominal frequency Nominal frequency of the local system hardware clock.
actual frequency Actual frequency of the local system hardware clock.
clock precision Precision of local system clock
clock offset Offsets of the local clock to the NTP server clock.
root delay Root delay from local equipment to the master reference
clock.
root dispersion Dispersion of the local clock relative to the NTP server
clock.
peer dispersion Dispersion of the remote NTP server.
reference time Reference timestamp.