3Com 5500G-EI - Voice VLAN Configuration Commands; Display Voice Vlan Oui; Display Voice Vlan Status

Voice VLAN Configuration Commands 85
Voice VLAN
Configuration
Commands
This section describes the commands you can use to configure voice VLANs.
display voice vlan oui Syntax
display voice vlan oui
View
Any view
Parameter
None
Description
Use the display voice vlan oui command to display the OUI address supported by
the current system and its relative features.
Related commands: voice vlan vlan_id enable, voice vlan enable.
Example
To display the OUI address of Voice VLAN, enter the following:
[SW5500]display voice vlan oui
Oui Address Mask Description
00e0-bb00-0000 ffff-ff00-0000 3com phone
0003-6b00-0000 ffff-ff00-0000 Cisco phone
00e0-7500-0000 ffff-ff00-0000 Polycom phone
00d0-1e00-0000 ffff-ff00-0000 Pingtel phone
00aa-bb00-0000 ffff-ff00-0000 ABC
display voice vlan status Syntax
display voice vlan status
View
Any view
Parameter
None
Description
Use the display voice vlan status command to display the relative Voice
VLAN features including the Voice VLAN status, the configuration mode, the
current Voice VLAN port status etc.
Related commands: voice vlan vlan_id enable, voice vlan enable.
Example
To enable the Voice VLAN on VLAN 2 and display the Voice VLAN status, enter the
following:
[SW5500]display voice vlan status