3Com 5500G-EI - Timer Response-Timeout

394 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Related commands: retry realtime-accounting, radius scheme.
Example
To set the real-time accounting interval of RADIUS scheme, “3Com”, to 15
minutes, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]timer realtime-accounting 15
timer response-timeout Syntax
timer response-timeout seconds
undo timer response-timeout
View
RADIUS Scheme View
Parameter
seconds : RADIUS server response timeout timer, ranging from 1 to 10 seconds. By
default, the value is 3.
Description
Use the timer response-timeout command to configure the RADIUS server
response timer.
Use the undo timer command to restore the default.
If the NAS receives no response from the RADIUS server after sending a RADIUS
request (authentication/authorization or accounting request) for a period of time,
the NAS resends the request, thus ensuring the user can obtain the RADIUS
service. You can specify this period by setting the RADIUS server response timeout
timer, taking into consideration the network condition and the desired system
performance.
Related commands: radius scheme, retry.
Example
To set the response timeout timer in the RADIUS scheme 3Com to 5 seconds,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
Tab le 53 Recommended ratio of minute to number of users
Number of users
Real-time accounting
interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
>1000 >15