3Com 5500G-EI - Display Info-Center; Display Logbuffer

458 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
display info-center Syntax
display info-center
View
All views
Parameter
None
Description
Use the display info-center command to display the configuration of system
log and the information recorded in the memory buffer.
If the information in the current log/trap buffer is less than the specified sizeval,
display the actual log/trap information.
For the related commands, see info-center enable, info-center loghost,
info-center logbuffer, info-center console channel, info-center
monitor channel
.
Example
Show the system log information.
<SW5500>display info-center
Information Center: enabled
Log host:
173.168.1.10, channel number:2, channel name:loghost,
language:english , host facility local:7
Console:
channel number:0, channel name:console
Monitor:
channel number:1, channel name:monitor
SNMP Agent:
channel number:5, channel name:snmpagent
Log buffer:
enabled, max buffer size:1024, current buffer size:256
current messages:6, channel number:4, channel name:logbuffer
dropped messages:0, overwrote messages:0
Trap buffer:
enabled, max buffer size:1024, current buffer size:256
current messages:0, channel number:3, channel
name:trapbuffer
dropped messages:0, overwrote messages:0
Information timestamp setting:
log - date, trap - date, debug - boot
XRN SWITCH OF this Device: LOG = disable; TRAP = disable; DEBUG =
enable
display logbuffer Syntax
display logbuffer [ level severity | size buffersize ]* [ | { begin |
exclude | include } regular-expression ]