3Com 5500G-EI - Display Ntp-Service Sessions; Display Ntp-Service Status

502 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
display ntp-service
sessions
Syntax
display ntp-service sessions [ verbose ]
View
All views.
Parameter
verbose: display detailed information about the sessions.
Description
Use the display ntp-service sessions command to display the status of all
the sessions maintained by NTP service provided by the local equipment.
By default, the status of all the sessions maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the verbose parameter, the Switch
will only display brief information about all the sessions it maintains.
With the verbose parameter configured, the Switch will display detailed
information about all the sessions it maintains.
Example
<SW5500>display ntp-service sessions
The information displays in the following format:
source refid st now poll reach delay offset disp
****************************************************************************
[12345]212.125.95.4 131.188.3.221 2 18 64 377 339.8 10.8 0.9
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
display ntp-service
status
Syntax
display ntp-service status
Views
All views.
Parameter
None
Description
Use the command display ntp-service status to display the NTP service
status.
Example
<SW5500>display ntp-service status
The information displays in the following format:
clock status: unsynchronized
clock stratum: 16
reference clock ID: none
nominal frequency: 100.0000 Hz