3Com 5500G-EI - Display Debugging; Display Version; System Debug Commands

System Debug Commands 447
display debugging Syntax
display debugging [ interface { interface-name | interface-type
interface-num } ] [ module-name ]
View
All views
Parameter
interface-name: Specify the Ethernet port name.
interface-type: Specify the Ethernet port type.
interface-num: Specify the Ethernet port number.
module-name: Specify the module name.
Description
Use the display debugging command to display the enabled debugging process.
Show all the enabled debugging when there is no parameter.
For the related commands, see debugging.
Example
Show all the enabled debugging.
<SW5500>display debugging
IP packet debugging switch is on.
display version Syntax
display version
View
All views
Parameter
None
Description
Use the display version command to view the software version, issue date and
the basic hardware configuration information.
Example
Display the information about the system version.
<SW5500>display version
System Debug
Commands
This section describes the system debugging options, and the system diagnostics
information that can be displayed on your Switch 5500G-EI.