290 CHAPTER 8: USING QOS/ACL COMMANDS
to
end-time end-date
:: The end date of a special time-range, together with
start-time start-date
means this special time-range is effective during a
certain period, notated as hh:mm MM/DD/YYYY.
If the above two parameters are not configured, it means there is no restriction to
time-range.
Description
Use the time-range command to configure a time range.
Use the undo time-range command to delete a time range.
If you input the parameter when using the undo time-range command, the
system will cancel the corresponding content of the parameters in the time range.
Example
Configure a time range to take effect at 00:00 on January 1, 2000 with no end
date specified.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]time-range test from 0:0 1-1-2000
QoS Configuration
Commands List
This section describes how to use the Quality of Service (QoS) configuration
commands on your Switch 5500G-EI.
display mirror Syntax
display mirror
View
Any view
Parameter
None
Description
Use the display mirror command to view port mirroring configuration,
including monitored ports, monitor port and monitor direction, and so on.
Related commands: mirroring-port, monitor-port.
Example
To display the port mirroring configuration, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500] display mirror
Monitor-port:
GigabitEthernet1/0/1
Mirroring-port:
GigabitEthernet1/0/2 both
To Next Page
Loading...
