174 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
Parameters
1 Enter to set the interface version to RIP-1.
2 Enter to set the interface version to RIP-2.
broadcast Enter to set the transmission mode of an RIP-2 packet to broadcast.
multicast Enter to set the transmission mode of an RIP-2 packet to multicast.
Description
Use the rip version command to configure the version number of RIP packets
on an interface.
Use the undo rip version command to restore the default RIP packet version on
the interface. The interface RIP version is RIP-1.
By default, RIP-1 transmits packets in broadcast mode, while RIP-2 transmits
packets in multicast mode.
When running RIP-1, the interface receives and transmits RIP-1 packets, and can
also receive RIP-2 broadcast packets.
When running RIP-2 in broadcast mode, the interface receives and transmits RIP-2
broadcast packets, and can also receive both RIP-1 packets and RIP-2 multicast
packets.
When running RIP-2 in multicast mode, the interface receives and transmits RIP-2
multicast packets, and can also receive RIP-2 broadcast packets. The interface can
not receive RIP-1 packets.
Example
To configure the interface Vlan-interface 1 to RIP-2 broadcast mode, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 1
[SW5500-Vlan-interface1]rip version 2 broadcast
rip work Syntax
rip work
undo rip work
View
Interface View
Parameter
None
Description
Use the rip work command to enable the RIP on an interface. This is the default.
To Next Page
Loading...
