3Com 5500G-EI - Display Fib Statistics; Display Icmp Statistics

134 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
127.0.0.1/32 127.0.0.1 U t[0] InLoopBack0
169.0.0.0/8 2.1.1.1 SU t[0] Vlan-interface1
display fib statistics Syntax
display fib statistics [ | { begin | include | exclude } text ]
View
Any View
Parameter
begin: Display the FIB entries from the first one containing the character string
text .
include: Display only those FIB entries containing the character string text .
exclude: Display only those FIB entries excluding the character string text .
text : String of specific characters.
Description
Use the display fib statistics command to view the total number of FIB
entries.
Example
To display the total number of FIB entries, enter the following:
<SW5500>display fib statistics
Route Entry Count : 30
display icmp statistics Syntax
display icmp statistics
View
Any View
Parameter
None
Description
Use the display icmp statistics command to view the statistics information
about ICMP packets.
Related commands: display ip interface reset ip statistics.
Example
To view statistics about ICMP packets, enter the following:
<SW5500> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 5 destination unreachable 0
source quench 0 redirects 0
echo reply 10 parameter problem 0