3Com 5500G-EI - Mac-Address Max-Mac-Count; Mac-Address Timer

434 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
[SW5500]mac-address static 00e0-fc01-0101 interface gigabitethernet
1/0/1 vlan 2
mac-address
max-mac-count
Syntax
mac-address max-mac-count count
undo mac-address max-mac-count
View
Ethernet port view
Parameter
count: Enter a value in the range 0 to 32768 to specify how many MAC
addresses a port can learn. 0 means that the port is not allowed to learn MAC
addresses.
Description
Use the mac-address max-mac-count command to configure the maximum
number of MAC addresses that can be learned by a specified Ethernet port. The
port stops learning MAC addresses when the specified limit is reached.
Use the undo mac-address-table max-mac-count command to cancel the
maximum limit on the number of MAC addresses learned by an Ethernet port. This
is the default. If you set no maximum limit, the MAC address table controls the
number of MAC addresses a port can learn.
Related commands: mac-address, mac-address timer
Examples
Configure the port GigabitEthernet 1/0/3 to learn at most 600 MAC addresses.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]inteface GigabitEthernet 1/0/3
[SW5500-GigabitEthernet1/0/3]mac-address max-mac-count 600
Cancel the maximum limit on the number of MAC addresses learned by the port
GigabitEthernet1/0/3.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]inteface GigabitEthernet 1/0/3
[SW5500-GigabitEthernet1/0/3]undo mac-address max-mac-count
mac-address timer Syntax
mac-address timer { aging age | no-aging }
undo mac-address timer aging
View
System view