3Com 5500G-EI - Debugging Arp Packet

ARP Configuration Commands 109
Description
Use the arp timer aging command to configure the dynamic ARP aging timer.
Use the undo arp timer aging command to restore the default time of 20
minutes.
Related commands: display arp timer aging
Example
To configure the dynamic ARP aging timer to 10 minutes, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]arp timer aging 10
debugging arp packet Syntax
debugging arp [ packet | error | info packet ]
undo debugging arp packet
View
User View
Parameters
None
Description
Use the debugging arp command to enable ARP debugging.
Use the undo debugging arp command to disable the corresponding ARP
debugging.
By default, undo ARP debugging is enabled.
For the related commands, see arp static and display arp.
Example
To enable ARP packet debugging, enter the following:
<SW5500>debugging arp packet
*0.771346-ARP-8-S1-arp_send:Send an ARP Packet, operation : 1,
sender_eth_addr :
00e0-fc00-3500,sender_ip_addr : 10.110.91.159, target_eth_addr :
0000-0000-0000
, target_ip_addr : 10.110.91.193
*0.771584-ARP-8-S1-arp_rcv:Receive an ARP Packet, operation : 2,
sender_eth_addr
: 0050-ba22-6fd7, sender_ip_addr : 10.110.91.193, target_eth_addr :
00e0-fc00-3500, target_ip_ad
dr : 10.110.91.159