3Com 5500G-EI - Idle-Timeout; Language-Mode

Logging in Commands 33
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface aux 0
[SW5500-ui-aux0]history-command max-size 20
idle-timeout Syntax
idle-timeout minutes [ seconds ]
undo idle-timeout
View
User interface view
Parameter
minutes: Enter the number of minutes you want to allow a user interface to
remain idle before it is disconnected. This can be in the range 0 to 35791.
seconds: Enter the number of seconds in addition to the number of minutes.
Optional.
Description
Use the idle-timeout command to configure the amount of time you want to
allow a user interface to remain idle before it is disconnected. Use the
undo
idle-timeout
command to restore the default idle-timeout. By default,
idle-timeout is set to 10 minutes.
To disable idle timeout, set the idle-timeout value to 0.
Example
To configure the timeout value to 1 minute on the AUX user interface, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface aux 0
[SW5500-ui-aux0]idle-timeout 1
language-mode Syntax
language-mode { chinese | english }
View
User View
Parameter
chinese: Sets the language of the command line interface to Chinese.
english: Sets the language of the command line interface to English.
Description
Use the language-mode command to choose the language of the command line
interface. By default, the command line interface is set to English.