3Com 5500G-EI - SNMP Configuration Commands; Display Snmp-Agent; Display Snmp-Agent Community

474 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Description
Use the terminal trapping command to enable terminal trap information
display. Use the
undo terminal trapping command to disable this function.
By default, this function is enabled.
Example
Enable trap information display.
<SW5500>terminal trapping
SNMP Configuration
Commands
This section displays the Simple Network Management Protocol (SNMP)
commands available on your Switch 5500G-EI.
display snmp-agent Syntax
display snmp-agent { local-engineid | remote-engineid }
View
All views
Parameter
local-engineid: local engine ID.
remote-engineid: remote engine ID.
Description
Use the display snmp-agent engineid command to view the engine ID of
current device.
SNMP engine is the core of SNMP entity. It performs the function of sending,
receiving and authenticating SNMP message, extracting PDU, packet
encapsulation and the communication with SNMP application, etc.
Example
Display the engine ID of current device.
<SW5500>display snmp-agent engineid
Local SNMP engineID: 00000009020000000C025808
display snmp-agent
community
Syntax
display snmp-agent community [ read | write ]
View
All views
Parameter
read: display read-only community information.
write: display read-write community information.