3Com 5500G-EI - Tcp Timer Fin-Timeout; Tcp Timer Syn-Timeout

IP Performance Configuration Commands 141
Example
To clear the UDP traffic statistics information, enter the following:
<SW5500>reset udp statistics
tcp timer fin-timeout Syntax
tcp timer fin-timeout time-value
undo tcp timer fin-timeout
View
System View
Parameter
time-value Enter the TCP finwait timer value in second, with the value ranging
from 76 to 3600; By default, 675 seconds.
Description
Use the tcp timer fin-timeout command to configure the TCP finwait timer.
Use the undo tcp timer fin-timeout command to restore the default value of
the TCP finwait timer.
When the TCP connection state changes from FIN_WATI_1 to FIN_WAIT_2, the
finwait timer is enabled. If the switch does not receive FIN packet before finwait
timer timeouts, the TCP connection will be terminated.
Related commands: tcp timer syn-timeout, tcp window.
Example
To configure the TCP finwait timer value as 800 seconds, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]tcp timer fin-timeout 800
tcp timer syn-timeout Syntax
tcp timer syn-timeout time-value
undo tcp timer syn-timeout
View
System View
Parameter
time-value Enter the TCP synwait timer value measured in second, whose value
ranges from 2 to 600. The default time-value is 75 seconds.
Description
Use the tcp timer syn-timeout command to configure the TCP synwait timer.