312 CHAPTER 8: USING QOS/ACL COMMANDS
Description
Using the acl command, you can reference ACL and implement the ACL control
to the TELNET users. Using the
undo acl command, you can remove the control
from the TELNET users.
Example
Perform ACL control to the users who access the local Switch using TELNET (basic
ACL 2000 has been defined).
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]user-interface vty 0 4
[SW5500-ui-vty0-4]acl 2000 inbound
ip http acl Syntax
ip http acl
acl-number
undo ip http acl
View
User Interface View
Parameter
acl-number
: Specifies a basic ACL with a number in the range of 2000 to 2999.
Description
Use the ip http acl command to call an ACL and perform ACL control over the
WEB network management users.
Use the undo ip http acl command to cancel the ACL control over the WEB
network management users.
This command calls numbered basic ACL only.
Example
To perform ACL control over the WEB network management users, enter the
following: (Suppose ACL 2020 has been defined.)
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]ip http acl 2020
snmp-agent community Syntax
snmp-agent community { read | write }
community-name
[ [ mib-view
view-name
] | [ acl
acl-number
] ]*
undo snmp-agent community
community-name
View
System View
To Next Page
Loading...
