3Com 5500G-EI - Display Resilient-Arp; Resilient-Arp Enable

Resilient ARP Configuration Commands 113
Example
To enable debugging resilient ARP packets, enter the following:
<SW5500>debugging resilient-arp packet
display resilient-arp Syntax
display resilient-arp [ unit unit-id ]
View
Any view
Parameter
unit-id Enter the unit ID, in the range of 1 to 8.
Description
Use the display resilient-arp command to view resilient ARP state
information of the units, the resilient ARP packet-sending VLAN interfaces.
If no unit ID is specified, the system displays the resilient ARP state information of
all units. Otherwise, the system only displays the resilient ARP state information of
the designated units.
Example
To display resilient ARP state information of Unit 1, enter the following:
<SW5500>display resilient-arp unit 1
The state of unit 1 is: L3Master
The sending interface(s):
Vlan-interface1
resilient-arp enable Syntax
resilient-arp enable
undo resilient-arp enable
View
System View
Parameter
None
Description
Use the resilient-arp enable command to enable the resilient ARP function.
Use the undo resilient-arp enable command to disable the resilient ARP
function.
By default, resilient ARP function is enabled.
For the related command, see display resilient-arp.