AAA Configuration Commands 359
AAA Configuration
Commands
This section describes how to use the AAA configuration commands on your
Switch 5500G-EI.
access-limit Syntax
access-limit { disable | enable
max-user-number
}
View
ISP Domain View
Parameter
disable: No limit to the supplicant number in the current ISP domain.
enable
max-user-number
: Specifies the maximum supplicant number in the
current ISP domain, ranging from 1 to 1048
Description
Use the access-limit command to configure a limit to the amount of
supplicants in the current ISP domain.
By default, there is no limit to the amount of supplicants in the current ISP domain.
This command limits the amount of supplicants contained in the current ISP
domain. The supplicants may contend with each other for the network resources.
So setting a suitable limit to the amount will guarantee the reliable performance
for the existing supplicants.
Example
Sets a limit of 500 supplicants for the ISP domain, marlboro.net.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]domain marlboro.net
New domain added.
[SW5500-isp-marlboro.net]access-limit enable 500
attribute Syntax
attribute { ip
ip-address
| mac
mac-address
| idle-cut
second
|
access-limit
max-user-number
| vlan
vlanid
| location { nas-ip
ip-address
port
portnum
| port
portnum
}
undo attribute {ip | mac | idle-cut | access-limit | vlan | location
}
View
Local User View
Parameter
idle-cut
second
: Allows/disallows the local users to enable the idle-cut
function. (The specific data for this function depends on the configuration of the
ISP domain where the users are located.) The argument
minute
defines the
idle-cut time, which is in the range of 60 to 7200 seconds.
To Next Page
Loading...
