3Com 5500G-EI - Display Qos-Interface Traffic-Redirect

294 CHAPTER 8: USING QOS/ACL COMMANDS
This command is used for displaying the traffic priority settings. The information
displayed includes the ACL corresponding to the traffic tagged with priority,
priority type and value.
Related command: traffic-priority.
Example
Display the traffic priority settings.
<SW5500>display qos-interface GigabitEthernet1/0/1 traffic-priority
GigabitEthernet1/0/1: traffic-priority
Inbound:
Matches: Acl 2000 rule 1 running
Priority action: cos best-effort
display qos-interface
traffic-redirect
Syntax
display qos-interface { interface-name | interface-type
interface-num | unit-id } traffic-redirect
View
Any view
Parameter
interface-name | interface-type interface-num: Interface of the Switch,
for more information, refer to the
port command in this manual.
unit-id : Unit ID of the Switch.
Description
Use the display qos-interface traffic-redirect command to view the
settings of the redirection parameters. The displayed content includes the
corresponding ACLs of the traffic to be redirected, the redirected interfaces, and
so on.
Related conmmand: traffic-redirect.
Example
Display the redirection parameter configuration.
<SW5500>display qos-interface gigabitethernet1/0/1 traffic-redirect
GigabitEthernet1/0/1: traffic-redirect
Inbound:
Matches: Acl 2000 rule 1 running
Redirected to: interface GigabitEthernet1/0/2
display qos-interface
traffic-statistic
Syntax
display qos-interface { interface-name | interface-type
interface-num | unit-id } traffic-statistic
View
All views