3Com 5500G-EI - Route Capacity Configuration Commands; Display Memory; Display Memory Limit

Route Capacity Configuration Commands 231
Route Capacity
Configuration
Commands
This section describes the commands you can use to configure route capacity on
the Switch.
display memory Syntax
display memory [ unit unit-id ]
Mode
Any View
Parameter
unit-id Enter the unit ID.
Description
Use the display memory command to view the memory setting.
Example
To display the current memory setting, enter the following:
<SW5500> display memory
Unit 1
System Available Memory(bytes): 92412672
System Used Memory(bytes): 25011700
Used Rate: 27%
The displayed information is defined in Table 41.
display memory limit Syntax
display memory limit
Mode
All Views
Parameter
None
Description
Use the display memory limit command to display the memory setting and
state information related to the Ethernet switch capacity, including available
memory and state information about connections, such as times for disconnecting
connections, times for reestablishing connections, and the current state of the
system.
Table 41 Output Description of the display memory Command
Item Description
Unit 1 Display the memory information of unit 1.
System Total Memory(bytes) The total number of the Switch memory in bytes.
Total Used Memory(bytes) The total number of the used Switch memory in bytes.
Used Rate The used rate of the Switch memory.