3Com 5500G-EI - Display Link-Aggregation Summary; Display Link-Aggregation Verbose

Ethernet Port Link Aggregation Commands 71
Description
Use the debugging lacp state command to enable LACP state machines
debugging on a designated port or ports. Use the
undo debugging lacp state
command to disable LACP state machines debugging on a designated port or
ports.
Example
To enable all LACP state machines debugging.
<SW5500>debugging lacp state all
display link-aggregation
summary
Syntax
display link-aggregation summary
View
Any view
Parameter
None
Description
Use the display link-aggregation summary command to view summary
information of all aggregation groups, including actor system ID, aggregation
group ID, aggregate group type, partner system ID, number of selected ports,
number of standby ports, load sharing type and master port number.
Example
To display summary information of all aggregation information, enter the
following:
<SW5500>display link-aggregation summary
Aggregation Group Type: D -- Dynamic, S -- Static, M -- Manual
Loadsharing Type: Shar – Loadsharing, NonS – Non-Loadsharing
Actor ID: 0x8000, 00e0-fcff-ff04
AL AL Partner ID Select Standby Share Master
ID Type Ports Ports Type Port
-------------------------------------------------------------------
1 D 0x8000,00e0-fcff-ff01 1 0 NonS Ethernet1/0/1
10 M none 1 0 NonS Ethernet1/0/2
20 S 0x8000,00e0-fcff-ff01 1 0 NonS Ethernet1/0/3
display link-aggregation
verbose
Syntax
display link-aggregation verbose [ agg_id ]
View
Any view
Parameter
agg_id: Aggregation group ID, which must be a valid existing ID, in the range of
1 to 464.