3Com 5500G-EI - Lacp System-Priority; Link-Aggregation Group Agg-ID Description

Ethernet Port Link Aggregation Commands 75
Description
Use the lacp port priority command to configure port priority value. Use the
undo lacp port-priority command to restore the default value.
Related commands: display link-aggregation verbose and display
link-aggregation interface
.
Example
To set port priority as 64, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]lacp port-priority 64
lacp system-priority Syntax
lacp system-priority system-priority-value
undo lacp system-priority
View
System View
Parameter
system-priority-value: System priority, ranging from 0 to 65535. By default, it
is 32768.
Description
Use the lacp system-priority command to configure system priority value.
Use the undo lacp system-priority command to restore the default value.
Related command: display lacp system-id.
Example
To set system priority as 64, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]lacp system-priority 64
link-aggregation group
agg-id description
Syntax
link-aggregation group agg_id description alname
undo link-aggregation group agg-id description
View
System View
Parameter
agg_id: Aggregation group ID, in the range of 1 to 464.