3Com 5500G-EI - Display Udp Statistics

IP Performance Configuration Commands 139
Parameter
None
Description
Use the display tcp status command to view the TCP connection state.
Example
To display the state of all TCP connections, enter the following:
<SW5500>display tcp status
TCPCB Local Add:port Foreign Add:port State
03e37dc4 0.0.0.0:4001 0.0.0.0:0 Listening
04217174 100.0.0.204:23 100.0.0.253:65508 Established
Table 16 Output Description of the display tcp status Command
display udp statistics Syntax
display udp statistics
View
Any View
Parameter
None
Description
Use the display udp statistics command to view UDP traffic statistic
information.
For related configuration, please refer to the reset udp statistics command.
Example
To display the UDP traffic statistic information, enter the following:
<SW5500>display udp statistics
Received packet:
Total:0
checksum error:0
shorter than header:0, data length larger than packet:0
no socket on port:0
broadcast:0
not delivered, input socket full:0
input packets missing pcb cache:0
Sent packet:
Total:0
Field Description
Local Add:port Local IP address: local port
Foreign Add:port Remote IP address; remote port
State State of the TCP link