3Com 5500G-EI - Display Qos-Interface Line-Rate; Display Qos-Interface Mirrored-To

292 CHAPTER 8: USING QOS/ACL COMMANDS
View
Any view
Parameter
interface-name | interface-type interface-num : Interface of the Switch, for
detailed a description, refer to the
port command in this manual.
unit-id : Unit ID of the Switch.
Description
Use the display qos-interface line-rate command to view the traffic rate
limitations of the interface output. If you do not specify interface parameters, you
will view the traffic rate limitations of all interfaces’ output. If you enter interface
parameters, you will view the parameter settings of traffic rate limitations of the
specified interfaces’ output.
Example
Display the parameter configuration of interface traffic rate limitation.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500] display qos-interface line-rate
GigabitEthernet1/0/1: line-rate
Outbound: 128 Kbps
display qos-interface
mirrored-to
Syntax
display qos-interface { interface-name | interface-type
interface-num | unit-id
} mirrored-to
View
Any view
Parameter
interface-name | interface-type interface-num : Interface of the Switch,
for detailed description, refer to the
port command in this manual.
unit-id : Unit ID of the Switch.
Description
Use the display qos-interface mirrored-to command to view the settings of
the traffic mirror.
This command is used for displaying the settings of traffic mirror. The information
displayed includes the ACL of traffic to be mirrored and the observing port.
Related command: mirrored-to.
Example
To display the settings of traffic mirror, enter the following:
<SW5500> display qos-interface gigabitethernet1/0/1 mirrored-to
GigabitEthernet1/0/1: mirrored-to