3Com 5500G-EI - Display Domain; Display Local-User

AAA Configuration Commands 363
display domain Syntax
display domain [ isp-name ]
View
All views
Parameter
isp-name: Specifies the ISP domain name, with a character string not exceeding
24 characters. The specified ISP domain shall have been created.
Description
Use the display domain command to view the configuration of a specified ISP
domain or display the summary information of all ISP domains.
This command is used to output the configuration of a specified ISP domain or
display the summary information of all ISP domains. If an ISP domain is specified,
the configuration information (content and format) will be displayed exactly the
same as the displayed information of the
display domain command. The output
information can help with ISP domain diagnosis and troubleshooting. Note that
the accounting scheme to be displayed should have been created.
Related commands: access-limit, domain, radius scheme, state, display
domain
.
Example
To display the summary information of all ISP domains of the system, enter the
following:
<SW5500>display domain
0 Domain = default system
State = Active
Scheme = Local Access-limit = Disable
Domain User Template:
Idle-cut = Disable
Self-service = Disable
Messenger Time = Disable
Default Domain Name: default_system
Total 1 domain(s).1 listed.
display local-user Syntax
display local-user [ domain isp-name | idle-cut { enable | disable }
| service-type { telnet | ftp | ssh | terminal | lan-access } |
state { active | block } | user-name user-name | vlan vlanid ]
View
All views
Parameter
domain isp-name : Configures to display all the local users in the specified ISP
domain.
isp-name specifies the ISP domain name with a character string not
exceeding 24 characters. The specified ISP domain shall have been created.