362 CHAPTER 11: USING AAA AND RADIUS COMMANDS
View
All views
Parameter
access-type { dot1x | mac-authentication }: Configures to display the
supplicants according to their logon type.
dot1x means the 802.1x users.
mac-authentication means the centralized mac address authentication users.
domain
domain-name
: Configures to display all the users in an ISP domain.
domain-name
specifies the ISP domain name with a character string not exceeding
24 characters. The specified ISP domain shall have been created.
mac
mac-address
: Configures to display the supplicant whose MAC address is
mac-address
. The argument
mac-address
is in the hexadecimal format (H-H-H).
radius-scheme
radius-scheme-name
: Configures to display the supplicant
according to RADIUS server name.
radius-scheme-name
specifies the RADIUS
server name with a character string not exceeding 32 characters.
interface
interface-type interface-number
: Configures to display the
supplicant according the port.
ip
ip-address
: Configures to display the user specified with IP address. The
argument
ipt-address
is in the hexadecimal format (ip-address).
vlan
vlanid
: Configures to display the user specified with VLAN ID. Here,
vlanid ranges from 1 to 4094.
ucibindex
ucib-index
: Configures to display the user specified with
ucib-index
. Here,
ucib-index
ranges from 0 to 4095.
user-name
user-name
: Configures to display a user specifies with
user-name
.
user-name
is the argument specifying the username. It is a character string not
exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @
character can only be used once in one username. The pure username (the part
before @, namely the user ID) cannot exceed 24 characters.
Description
Use the display connection command to view the relevant information of all
the supplicants or the specified one(s).
The output can help you with the user connection diagnosis and troubleshooting.
If no parameter is specified, this command displays the related information about
all connected users
Related command: cut connection.
Example
To display the relevant information of all the users, enter the following:
<SW5500>display connection
Total 0 connections matched ,0 listed.
To Next Page
Loading...
