446 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Description
Use the display clock command to obtain information about system data and
time from the terminal display..
For the related commands, see clock.
Example
View the current system date and clock.
<SW5500>display clock
15:50:45 UTC Mon 2001/2/12
display config-agent Syntax
display config-agent unit-id
unit-id
View
Any view
Parameter
unit-id
: Unit ID of current switch, in the range of 1 to 8.
Description
Use the display config-agent unit-id command to view statistics of the
configuration agent.
Configuration agent is one of the XRN features. You can log into one switch of the
fabric to configure and manage the fabric by the configuration agent. The
functions of the configuration agent include;
■ Distributing configuration commands to the right destination switches or
processing modules based on the resolution result of the commands input.
■ Sending output information of the commands from the switch you have
logged into to your terminal.
■ Supporting simultaneous configuration of multiple users.
You cannot configure the configuration agent, but can view the statistics of the
configuration agent.
Example
To display statistics of the configuration agent on switch 1, enter the following:
<SW5500>display config-agent unit-id 1
Config-agent info on Unit1
Successful Failed on
Config message recv: 10 0
Config message send: 10 0
Notification message recv: 10 0
Notification message send: 10 0
Information message recv: 3 0
Information message send: 1 0
To Next Page
Loading...
