3Com 5500G-EI - Startup Saved-Configuration; FTP Server Configuration Commands

416 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
If you do not enter the file-name parameter in this command, for the switches that
have specified the configuration file for booting, the current configurations will be
stored to the specified configuration file; and for the switches that have not
specified the configuration file for booting, the current configurations will be
stored to the default configuration file, 3comoscfg.cfg.
Related commands: reset saved-configuration, display
current-configuration, display saved-configuration.
Example
Get the current configuration files stored in flash memory.
<SW5500>save
The configuration will be written to the device.
Are you sure?[Y/N] y
Please input the file name(*.cfg)[flash:/sw5500cfg.cfg]:
Now saving current configuration to the device.
Saving configuration. Please wait .....
..........
startup saved
startup
saved-configuration
Syntax
startup saved-configuration [ unit unit-id ] cfgfile
View
User view
Parameter
unit unit-id : Specify the Unit ID of switch.
cfgfile : The name of the configuration file. It is a string with a length of 5 to 56
characters.
Description
Use the startup saved-configuration command to configure the configuration
file used for enabling the system for the next time.
The configuration file must have ".cfg" as its extension name and must be saved
under the root directory of the Flash.
For the related command, please see display startup
Example
Configure the configuration file for the next start-up.
<SW5500>startup saved-configuration sw5500cfg.cfg
FTP Server
Configuration
Commands
This section describes how to use the File Transfer Protocol (FTP) configuration
commands on your Switch 5500G-EI.