3Com 5500G-EI - Display Rip Interface

RIP Configuration Commands 161
Example
To display the current running state and configuration information of RIP, enter the
following:
<SW5500>display rip
RIP is running
public net VPN-Instance
Checkzero is on Default cost : 1
Summary is on Preference : 100
Traffic-share-across-interface is off
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
display rip interface Syntax
display rip interface
View
All views
Parameter
None
Description
Use the display rip interface command to view RIP interface information.
Example
To display rip interface information, enter the following:
<SW5500>display rip interface
RIP Interface: public net
Address Interface Ver MetrIn/Out Input Output Split-horizon
1.0.0.1 Vlan-inteface1002 0/1 on on on
Table 22 Output Description of the display rip Command
Field Description
RIP is running RIP is active
Checkzero is on Zero field checking is enabled
Default cost:1 The default route cost is 1
Summary is on Routes are summarized automatically
Preference: 100 The preference of RIP is 100
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
The three RIP timers
No peer router No destination address of a transmission is specified
Network: 202.38.168.0 RIP enabled on network segment 202.38.168.0