3Com 5500G-EI - Ospf Cost; Ospf Dr-Priority

OSPF Configuration Commands 207
[SW5500-ospf-1]area 1
[SW5500-ospf-1-area-0.0.0.1]network 131.119.0.0 0.0.255.255
[SW5500-ospf-1-area-0.0.0.1]authentication-mode md5
[SW5500-ospf-1-area-0.0.0.1]quit
[SW5500-ospf-1]quit
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ospf authentication-mode md5 15 3Com
ospf cost Syntax
ospf cost value
undo ospf cost
View
VLAN Interface view
Parameter
value Enter the cost for running the OSPF protocol, in the range 1 to 65535.
Description
Using the ospf cost command, you can configure the cost of sending traffic from
each interface.
Using the undo ospf cost command, you can restore the default costs.
For the Switch 5500-EI, the default cost for running OSPF protocol of on a VLAN
interface is 10.
Example
To specify a cost of 33 when the interface vlan-interface 1 runs OSPF, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ospf cost 33
ospf dr-priority Syntax
ospf dr-priority value
undo ospf dr-priority
View
VLAN Interface view
Parameter
value Enter the interface priority for electing the "designated router", ranging
from 0 to 255. The default value is 1.