3Com 5500G-EI - Display Logbuffer Summary; Display Trapbuffer

460 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Dropped messages : 0
Overwritten messages : 0
Current messages : 91
display logbuffer
summary
Syntax
display logbuffer summary [ level severity ]
View
Any view
Parameter
level: Information level.
severity: Information level, do not output information below this level. By default,
the log information level is warnings, the trap information level is debugging, the
debugging information level is debugging.
Information at different levels is as follows:
■ emergencies: Level 1 information, which cannot be used by the system.
■ alerts: Level 2 information, to be reacted immediately.
■ critical: Level 3 information, critical information.
■ errors: Level 4 information, error information.
■ warnings: level 5 information, warning information.
■ notifications: Level 6 information, showed normally and important.
■ informational: Level 7 information, notice to be recorded.
■ debugging: Level 8 information, generated during the debugging progress.
Description
Using display logbuffer summary command, you can view the summary
information recorded in logbuffer.
For the related commands, see info-center enable, info-center loghost,
info-center logbuffer
, info-center console channel, info-center
monitor channel.
Example
Show the summary information recorded in logbuffer.
<SW5500>display logbuffer summary
EMERG ALERT CRIT ERROR WARN NOTIF INFO DEBUG
0 0 0 0 94 0 1 0
display trapbuffer Syntax
display trapbuffer [ size buffersize ]
View
Any view