402 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
■ ntp-service unicast-peer
■ ntp-service unicast-server
SSH Configuration Commands
■ debugging ssh server
■ display rsa local-key-pair public
■ display rsa peer-public-key
■ display ssh server
■ display ssh user-information
■ peer-public-key end
■ protocol inbound
■ public-key-code begin
■ public-key-code end
■ rsa local-key-pair create
■ rsa local-key-pair destroy
■ rsa peer-public-key
■ ssh server authentication-retries
■ ssh server rekey-interval
■ ssh server timeout
■ ssh user assign rsa-key
■ ssh user username authentication-type
File System
Management
Commands
This section describes the commands you can use to manage the file system on
your Switch 5500G-EI.
In switches supporting the XRN feature, the file path must start with
"unit[No.]>flash:/:", the [No.] is the unit ID. For example, suppose unit ID is 1, and
the path of the "text.txt" file under the root directory must be
"unit1>flash:/text.txt".
cd Syntax
cd
directory
View
User view
Parameter
directory:
Destination directory. The default directory is the working path
configured by the user when the system starts.
Description
Use the cd command to change the current user configuration path on the
Switch.
To Next Page
Loading...
