3Com 5500G-EI - Display Stop-Accounting-Buffer

378 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Code= 5,Num=0 ,Err=0
Code=11,Num=0 ,Err=0
Code=22,Num=0 ,Err=0
Running statistic:
RADIUS received messages statistic:
Normal auth request ,Num=0 ,Err=0 ,Succ=0
EAP auth request ,Num=0 ,Err=0 ,Succ=0
Account request ,Num=0 ,Err=0 ,Succ=0
Account off request ,Num=0 ,Err=0 ,Succ=0
Leaving request ,Num=0 ,Err=0 ,Succ=0
display
stop-accounting-buffer
Syntax
display stop-accounting-buffer { radius-scheme radius-scheme-name |
session-id
session-id | time-range start-time stop-time | user-name
user-name }
View
All views
Parameter
radius-scheme radius-scheme-name : Configures to display the saved stopping
accounting requests according to RADIUS server name.
radius-scheme-name
specifies the RADIUS server name with a character string not exceeding 32
characters.
session-id session-id : Configures to display the saved stopping accounting
requests according to the session ID.
session-id specifies the session ID with a
character string not exceeding 50 characters.
time-range start-time stop-time : Configures to display the saved stopping
accounting requests according to the saving time.
Start-time specifies the start
time of the saving time range and
stop-time specifies the stop time of the saving
time range. The time is expressed in the format hh:mm:ss-yyyy/mm/dd. When this
parameter is specified, all the stopping accounting requests saved in the time
range since
start-time to stop-time will be displayed.
user-name user-name : Configures to display the saved stopping accounting
requests according to the username.
User-name specifies the username, a
character string not exceeding 32 characters,. The @ character can only be used
once in one username. The pure username (the part before @, namely the user ID)
cannot exceed 24 characters.
Description
Use the display stop-accounting-buffer command to view the stopping
accounting requests, which have not been responded and saved in the buffer.
After transmitting the stopping accounting requests, if there is no response from
the RADIUS server, the Switch will save the packet in the buffer and retransmit it
for several times, which is set through the
retry realtime-accounting.
This command is used to display the stopping accounting requests saved in the
Switch buffer. You can select to display the packets sent to a certain RADIUS