476 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
display snmp-agent
mib-view
Syntax
display snmp-agent mib-view [ exclude | include | viewname
mib-view
]
View
All views
Parameter
exclude: Display the SNMP mib view excluded.
include: Display the SNMP mib view included.
viewname: Display the SNMP mib view according to the mib view name.
mib-view:
Specify the mib view name.
Description
The display snmp-agent mib-view command is used to view the MIB view
configuration information of the Switch.
Example
Display the information about the currently configured MIB view.
<SW5500>display snmp-agent mib-view
View name:mv MIB Subtree:internet
Storage-type: nonVolatile -included active
View name:test MIB Subtree:internet
Storage-type: nonVolatile -included active
View name:ViewDefault MIB Subtree:internet
Storage-type: nonVolatile -included active
View name:ViewDefault MIB Subtree:snmpUsmMIB
Storage-type: nonVolatile -excluded active
View name:ViewDefault MIB Subtree:snmpVacmMIB
Storage-type: nonVolatile -excluded active
View name:ViewDefault MIB Subtree:snmpModules.18
Storage-type: nonVolatile -excluded active
The following table describes the output fields.
If the SNMP Agent is disabled, "Snmp Agent disabled" will be displayed after you
execute the above display commands.
Tab le 59 Output description of the display snmp-agent mib-view command
Field Description
View name View name
MIB Subtree MIB subtree
storage-type Storage type
included/excluded Permit or forbid access to a MIB object
active Indicate the line state in the table
To Next Page
Loading...
