3Com 5500G-EI - UDP Helper Configuration Commands; Debugging Udp-Helper; Display Udp-Helper Server

128 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Example
To add Ethernet1/0/1 and Ethernet1/0/2 to isolation group, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]port isolate
[SW5500-GigabitEthernet1/0/1]quit
[SW5500]interface gigabitethernet 1/0/2
[SW5500-GigabitEthernet1/0/2]port isolate
UDP Helper
Configuration
Commands
This section describes the commands you can use to configure and manage the
UDP Helper Configuration operations on your Switch.
debugging udp-helper Syntax
debugging udp-helper { event | packet [ receive | send ] }
undo debugging udp-helper { event | packet [ receive | send ] }
View
User view
Parameters
event UDP Helper event debugging.
packet UDP Helper packet debugging.
receive UDP Helper inbound packet debugging.
send UDP Helper outbound packet debugging.
Description
Use the debugging udp-helper command to enable UDP Helper debugging.
Use the undo debugging udp-helper command to disable UDP Helper
debugging.
By default, UDP Helper debugging is disabled.
Example
To enable UDP Helper packet debugging, enter the following:
<SW5500>debugging udp-helper packet
display udp-helper
server
Syntax
display udp-helper server [ interface vlan-interface vlan_id ]
View
Any view