3Com 5500G-EI - IP Performance Configuration Commands; Display Fib; Display Fib Ip_Address

IP Performance Configuration Commands 131
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]udp-helper server 192.1.1.2
IP Performance
Configuration
Commands
This section describes the commands you can use to configure and manage the IP
Performance Configuration operations on your Switch 5500G-EI.
display fib Syntax
display fib
View
Any view
Parameter
none
Description
Use the display fib command to view the summary of the forwarding
information base. The information includes: destination address/mask length, next
hop, current flag, timestamp and outbound interface.
Example
To display the summary of the Forwarding Information Base, enter the following:
<SW5500>display fib
Destination/Mask Nexthop Flag TimeStamp Interface
127.0.0.0/8 127.0.0.1 U t[0] InLoopBack0
display fib ip_address Syntax
display fib ip_address1 [ { mask1 | mask-length1 } [ ip_address2 {
mask2 | mask-length2 } | longer ] | longer ]
View
Any view
Table 12 Description of the output information of the display fib command
Field Description
Flag
The flag options include:
B – Blackhole route
D – Dynamic route
G – Gateway route
H – Local host route
S – Static route
U – Route in UP status
R – Unreachable route
L – Route generated by ARP or ESIS