OSPF Configuration Commands 203
undo import-route
protocol
View
OSPF View
Parameter
protocol
Enter the source routing protocol to be imported. This can be one of the
following:
direct, rip, and static.
route-policy
route_policy_name
Enter a route policy name. Only routes that
match the specified route policy are imported.
cost
value
Enter the cost of the imported route.
type
value
Enter the cost type of imported routes. The value can be 1 or 2. The
default value is 2.
tag
value
Enter the tag value for imported external routes.
Description
Using the import-route command, you can import the external routing
information of another routing protocol.
Using the undo import-route command, you can cancel the import of external
routing information. By default, the routing information of other protocols is not
imported.
3Com recommends that you configure the route type, cost, and tag together in
one command; otherwise, the new configuration overwrites the old one.
Example
To configure an imported RIP route with the external route of type 2, a route tag
of 33 and a route cost of 50, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]import-route rip type 2 tag 33 cost 50
network Syntax
network
ip
_
address
ip_mask
undo network
ip_address ip_mask
View
OSPF Area view
Parameter
ip_address
Enter the IP address of the network segment where the interface is
located.
To Next Page
Loading...
