114 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Example
To enable the resilient ARP function, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]resilient-arp enable
resilient-arp interface
vlan-interface
Syntax
resilient-arp interface vlan-interface
vlan-id
undo resilient-arp interface vlan-interface
vlan-id
View
System View
Parameter
vlan-id
Enter the
VLAN interface ID.
Description
Use the resilient-arp interface vlan-interface command to configure the
Switch to send resilient ARP packets out the specified VLAN interface.
Use the undo resilient-arp interface vlan-interface command to stop the
Switch from sending ARP packets out of the specified VLAN interface.
By default, the system sends resilient ARP packets out of VLAN interface 1.
For the related command, see display resilient-arp.
Example
To set VLAN interface 2 to send resilient ARP packets., enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]resilient-arp interface vlan-interface 2
To Next Page
Loading...
