QoS Configuration Commands List 295
Parameter
interface-name | interface-type interface-num:
Specifies a port of the
Switch. For detailed information, refer to the
port command in this manual.
unit-id
:: Unit ID of the Switch.
Description
Use the display qos-interface traffic-statistic command to view the
traffic statistics information. The information displayed includes the ACL
corresponding to the traffic to be counted and the number of packets counted.
Related command: traffic-statistic.
Example
Display the traffic statistics information.
<SW5500>display qos-interface gigabitethernet1/0/1 traffic-statistic
GigabitEthernet1/0/1: traffic-statistic
Inbound:
Matches: Acl 2000 rule 1 running
0 packet inprofile
0 packet outprofile
display queue-scheduler Syntax
display queue-scheduler
View
Any view
Parameter
None
Description
Use the display queue-scheduler command to view queue scheduling mode
and corresponding parameter configuration.
The default is Weighted Round Robin.
Related command: queue-scheduler.
Example
To display the queue scheduling mode, enter the following:
<SW5500> display queue-scheduler
Queue scheduling mode: weighted round robin
weight of queue 0: 1
weight of queue 1: 2
weight of queue 2: 3
weight of queue 3: 4
weight of queue 4: 5
weight of queue 5: 6
weight of queue 6: 7
weight of queue 7: 8
To Next Page
Loading...
