196 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
display ospf peer Syntax
display ospf [
process-id
] peer [ brief ]
View
All Views
Parameter
process-id
Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the display ospf peer command to view detailed OSPF peer information.
Use the display ospf peer brief command to view brief information of every
peer in the OSPF Autonomous System, in particular the peer number of all states
in every area.
Example
To view the information on an SPF peer, enter the following:
<SW5500>display ospf peer
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Neighbors
Area 0.0.0.0 interface 10.153.17.88(Vlan interface1)’s
neighbor(s)
RouterID: 2.2.2.2 Address: 10.153.17.89
State: Full Mode: Nbr is Master Priority: 1
DR: 10.153.17.89 BDR: 10.153.17.88
Dead times expires in 31s
Neighbor has been up for 01:14:14
Tab le 33 Output Description of the display ospf nexthop Command
Field Description
Address Address of the next hop
Type Type of the next hop
Refcount Reference count of the next hop, that is, number of routes using the
next hop
Intf Addr IP address of the interface to the next hop
Intf Name The interface to the next hop
Tab le 34 Output Description of the display ospf peer Command
Field Description
RouterID Router ID of neighbor router
Address Address of the interface, through which neighbor router
communicates with the router
State State of adjacency relation
To Next Page
Loading...
