3Com 5500G-EI - BOOTP Client Configuration Commands; Debugging Dhcp Xrn Xha; Ip Address Bootp-Alloc

BOOTP Client Configuration Commands 115
BOOTP Client
Configuration
Commands
This section describes the commands you can use to configure and manage the
BOOTP Client operations on your Switch 5500G-EI.
debugging dhcp xrn xha Syntax
debugging dhcp xrn xha
undo debugging dhcp xrn xha
View
User view
Parameter
None
Description
Use the debugging dhcp xrn xha command to enable BOOTP client hot backup
debugging.
Use the undo debugging dhcp xrn xha command to disable BOOTP client hot
backup debugging.
By default, BOOTP client hot backup debugging is disabled.
Example
To enable BOOTP client hot backup debugging, enter the following:
<SW5500>debugging dhcp xrn xha
ip address bootp-alloc Syntax
ip address bootp-alloc
undo ip address bootp-alloc
View
VLAN Interface View
Parameter
None
Description
Use the ip address bootp-alloc command to configure VLAN interface to
obtain IP address using BOOTP.
Use the undo ip address bootp-alloc command to remove the configuration.
By default, the VLAN interface does not obtain an IP address using BOOTP.
Related command: display bootp client