3Com 5500G-EI - Snmp-Agent Trap Queue-Size; Snmp-Agent Trap Source

488 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
For the related commands, see snmp-agent trap enable,
snmp-agent target-host.
Example
Configure the timeout interval of Trap packet as 60 seconds.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap life 60
snmp-agent trap
queue-size
Syntax
snmp-agent trap queue-size length
undo snmp-agent trap queue-size
View
System view
Parameter
length: Length of queue, ranging from 1 to 1000; the default length is 100.
Description
Use the snmp-agent trap queue-size command to configure the information
queue length of Trap packet sent to destination host. Use the
undo snmp-agent
trap queue-size
command to restore the default value.
For the related commands, see snmp-agent trap enable,
snmp-agent target-host, snmp-agent trap life.
Example
Configure the queue length to 200.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap queue-size 200
snmp-agent trap source Syntax
snmp-agent trap source vlan-interface vlan-id
undo snmp-agent trap source
View
System view
Parameter
vlan-id: Specify the VLAN interface ID, ranging from 1 to 4094.
Description
Use the snmp-agent trap source command to specify the source address for
sending Traps. Use the
undo snmp-agent trap source command to cancel the
source address for sending Traps.