3Com 5500G-EI - Display Ip Socket

IP Performance Configuration Commands 135
timestamp 0 information request 0
mask requests 0 mask replies 0
time exceeded 0
Output:echo 10 destination unreachable 0
source quench 0 redirects 0
echo reply 5 parameter problem 0
timestamp 0 information reply 0
mask requests 0 mask replies 0
time exceeded 0
display ip socket Syntax
display ip socket [ socktype sock-type ] [ task-id socket-id ]
View
Any View
Parameters
sock-type Enter the type of a socket: (tcp:1, udp 2, raw ip 3).
task-id Enter the ID of a task, with the value ranging from 1 to 100.
socket-id Enter the ID of a socket, with the value ranging from 0 to 3072.
Description
Use the display ip socket command to display the information about the
sockets in the current system.
Example
To display the information about the socket of TCP type, enter the following:
<SW5500>display ip socket socktype 1
SOCK_STREAM:
Task = VTYD(18), socketid = 1, Proto = 6,
Table 13 Output Description of the display icmp statistics Command
Field Description
bad formats Number of input packets in bad format
bad checksum Number of input packets with wrong checksum
echo Number of input/output echo request packets
destination unreachable Number of input/output packets with unreachable destination
source quench Number of input/output source quench packets
redirects Number of input/output redirected packets
echo reply Number of input/output echo reply packets
parameter problem Number of input/output packets with parameter problem
timestamp Number of input/output timestamp packets
information request Number of input information request packets
mask requests Number of input/output mask request packets
mask replies Number of input/output mask reply packets
information reply Number of output information reply packets
time exceeded Number of time exceeded packets