414 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
configurations of the protocol views are displayed when executing this command
in protocol sub-views.
For the related command, see save, reset, saved-configuration, display
current-configuration, display saved-configuration
.
Example
Display the configuration parameters for the current view of the switch system.
[SW5500]display this
display startup Syntax
display startup [ unit
unit-id
]
View
All views
Parameter
unit
unit-id
: Specify the Unit ID of switch.
Description
Use the display startup command, to display the related system software and
configuration filenames used for the current and the next start-ups.
This command is used to display the following information:
■ Filename of the system software configured by the user
■ Filename of the system software actually used for this startup
■ Filename of the system software configured for the next startup
■ Configuration filename used for the current startup
■ Configuration filename configured for the next startup.
For the related command, see startup saved-configuration.
Example
Display the filenames related to the current and the next enabling.
<SW5500>display startup
UNIT1:
Startup saved-configuration file: flash:/sw5500cfg.cfg
Next startup saved-configuration file: flash:/sw5500cfg.cfg
Bootrom-access enable state: enabled
reset
saved-configuration
Syntax
reset saved-configuration
View
User view
To Next Page
Loading...
