3Com 5500G-EI - Resilient ARP Configuration Commands; Debugging Resilient-Arp

112 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Description
Use the reset arp command to remove information that is no longer required
from the ARP mapping table. You can remove entries of a specified type, or from a
specified port.
Use the reset arp command to clear all ARP entries. You are asked to confirm
this entry.
Use the reset arp dynamic command to clear all dynamic ARP entries.
Use the reset arp static command to clear all static ARP entries.
Use the display arp interface command to clear all entries for the specified
port.
Related command: arp static, display arp.
Example
To clear static ARP entries, enter the following:
<SW5500>reset arp static
Resilient ARP
Configuration
Commands
This section describes the commands you can use to configure and manage the
Resilient ARP operations
debugging resilient-arp Syntax
debugging resilient-arp { packet | state | error | all }
undo debugging resilient-arp { packet | state | error | all }
View
User view
Parameters
packet Enter to enable debugging resilient ARP packets.
state Enter to enable debugging resilient ARP state machine.
error Enter to enable debugging resilient ARP errors (including packet errors).
all Enter to enable all resilient ARP debugging.
Description
Use the debugging resilient-arp command to enable resilient ARP debugging.
Use the undo debugging resilient-arp command to disable resilient ARP
debugging.
By default, all resilient ARP debugging is disabled.